1. Nayan Naware
  2. UVM
  3. Friday, March 31 2017, 04:17 AM
Backdoor and front door register access ??
Admin Accepted Answer Pending Moderation
Thanks for asking these questions, I'll put a post on this soon.

A simple explanation is that frontdoor utilizes the register peripheral bus to drive protocol transactions to the design. This is the real use case scenario where a processor core can access the register space within the design via the peripheral bus. An example would be when the design has an APB interface for its registers, and the UVM environment sends APB transactions to the design with an address and data to read/write a particular register.

The backdoor is a technique to directly put/get the value onto the register variable in the design RTL signal, for which you have to build up the hierarchical path to the registers. Backdoor does not consume any simulation time, and is faster. But it is quite insufficient to be the only mode of verification. This is usually done during the early testbench development phase or when agents that can drive transactions to the DUT are not available.
  1. more than a month ago
  2. UVM
  3. # 1
Prashant Kukadiya Accepted Answer Pending Moderation
Can you provide me a example of frontdoor and backdoor access ?
  1. 2 weeks ago
  2. UVM
  3. # 2
  • Page :
  • 1

There are no replies made for this post yet.
However, you are not allowed to reply to this post.